Century Helicopter Products PredatorSE Instruction Manual download pdf (Page 5)

5

#HI6189

Bell Mixing

Arm

#HW6001

M3x18 Special

Shoulder Bolt

#CNBB37F

M3x7 Flange Ball

Bearing x 2

#CNLR1014

Short Ball

#CNLR1020

Medium Ball

Press one M3x7 anged ball bearing into

one side followed by one M3x5 spacer and

another anged bearing from the opposite

side. If the bearing is tight, lightly sand the

bell mixer and use L262 Red threadlock

to bond the bearing in place. Install the

CNLR1014 short steel ball into the single

hole side of the bell mixer and install the

CNLR1020 medium steel ball using L242

Blue threadlock. Install the medium steel

ball according to the table to suit your y-

ing preference. Use the center hole for sport

ying. Make two assemblies.

Step 4 Bell Mixer

Press one M8x16 ball bearing into both ends of

each main rotor blade grip. Slide one M14 thrust

washer against the bearing closest to the main

rotor blade. Make sure that the bearing and the

thrust washer are properly seated into the deep

end of the blade grip. If necessary use a socket

that matches the outside diameter of the bearing

and press into position. Make two assemblies.

1:1.6 3D

1:1.3 3D & Sport

1:1 Sport & FAI

Bell Mixer Ratios

#HI6184A

Main Blade

Grip

#CNBB816

M8x16 Ball

Bearing

#HW6183

M14 Thrust

Washer

M3x18 Special Socket

Shoulder Screw

#HW6001

#CNLR1014

Short Ball

Step 5 Main Blade Grip

Bell Mixer

Assembly

#HW6205

M3x5x3

Spacer

Step 6 Main Blade Grip Assembly

Using an available M3 screw, care-

fully form the threads in the blade

grip arm. Slide the M3x18 special

socket shoulder screw through the

bell mixer arm from the at side, add

one M3x5x3 spacer and apply a drop

of Slow Cyanoacrylate glue or Epoxy

glue to the end of the threads before

installing into the blade grip. Tighten

the bolt until there is no end to end

movement, but do not overtighten

the bolt as you can strip out the hole.

Make two assemblies.

Slow cyanoacrylate

or Epoxy glue

Blade Grip assembly

from Step 5

#HW6205

M3x5x3 Steel

Spacer x 2

#CNLR1020

Medium Ball

1 2 3 4 5 6 7 8 9 10 ... 37 38

Comments to this Manuals

No comments